![]() Choose a Layer on which to place the routed elements. Adjust additional Routing Options as needed. Choose an MEP System attribute for this Routing operation.ħ. In this image, the reference line during routing runs along the top left corner of the duct, as viewed in the direction of routing.Ħ. You can switch this location en route as needed.) ![]() (This reference line is relevant only during a Routing operation, and indicates the anchor point of the routed elements when you click on screen to place them. Reference Line location/Elevation: Choose one of the nine points in the Routing palette to define the location of the reference line of the routed elements, at the given elevation. Once you start routing, you can switch to another routing elevation as you proceed. All new routes are set to “ Constant Elevation” (the horizontal arrow). The Construction Method is not editable until after you start Routing. Hover over each icon to preview the name of each tool. ( Options > Project Preferences > MEP Preferences).Ĥ. EnRoute tools are activated by selecting the corresponding tool icon from the toolbar ribbon at the top of the display. The Installation Wizard will then appear. Rather than extract the zip folder, you can double click it to open it like a folder and then double click to open the. The majority of systems are 64-bit these days so you wont be using this one. – The list of predefined Duct and Pipe sizes can be edited in MEP Preferences. EnRouteXInstaller32bit.zip: Use this if your operating system is 32-bit. – Enter a predefined height or width from the pop-up, or choose Custom to type in any custom value. Enter a diameter or height/width values for the cross-section, as applicable. The EnRoute 4. Choose a cross-section geometry preference for the routed elements: Rectangular, Circular, Oval or (Ductwork only) Flexible.ģ. Choose either Ductwork, Pipework or Cabling from the top dropdown menu.Ģ. These options can be changed in the midst of a routing operation.ġ. ![]() Set the desired options on the MEP Routing palette ( Window > Palettes > MEP Routing). ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |